Difference between revisions of "Ant PCB Maker"
| Line 15: | Line 15: | ||
* Flatcam 8.97 Beta | * Flatcam 8.97 Beta | ||
* bCNC | * bCNC | ||
| + | |||
| + | == Software installation == | ||
| + | The instructions below were tested on Debian 10, with contrib, non-free and backports repositories enabled. | ||
| + | === Flatcam === | ||
| + | === bCNC === | ||
Revision as of 22:23, 7 September 2019
| Project: Ant PCB Maker | |
|---|---|
| Featured: | No |
| State | Active |
| Members | Adnub |
| GitHub | No GitHub project defined. Add your project here. |
| Description | Creation of an Ant PCB Maker to prototype PCB design.
Also create needed manuals on how to operate it. |
| Picture | |
| |
Hardware completed. Documentation work in progress
Characeristics
- Maximum supported size of PCBs: 150mm x 80mm
- DC power supply: 12V 10A
Software used
- Flatcam 8.97 Beta
- bCNC
Software installation
The instructions below were tested on Debian 10, with contrib, non-free and backports repositories enabled.
